明尼罗塔迪纳克斯7xi电池盖锁扣3D模型

Minolta Dynax 7xi battery door latch

2024-04-02 06:34:30

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

With ages, old plastic becomes fragile and the camera battery door latch could be broken, leaving you with unavailability to hold your battery inside camera.
Here is the replacement for the broken latch used in Minolta Dynax 7xi.

Print Settings

Printer brand:
Flying Bear
Printer:
Ghost 6
Rafts:
Yes
Supports:
Yes
Resolution:
0.1
Notes:
Rafts and supports are not necessary, but it's better to use them.
0.1 layer thickness gives better results on such small print, but 0.2 is OK too. 0.4 nozzle was used by me, because I don't have others, smaller nozzles will give better results.

Post-Printing

Installation. Step 1

Unscrew the bottom part of the camera as it is used to hold the shaft of the door.

Usually, it's not needed to unscrew the whole bottom, but 2 little screws on the same side as the battery, and a long screw on the center. It will give you an opportunity to lift the door side up and to get it out of the body.

Installation. Step 2

Use a soldering tool on 4 little plastic pins holding the metal plate on the inner side of the door.
Use some sharp tool to lift the plate from the door.