2.5" Hose Attachments for Shapeoko 5 Pro 2' x 4'

2024-04-02 17:25:55

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

2.5" Hose Attachments for Shapeoko 5 Pro 2' x 4'

Summary

In my infinite wisdom, I built my Shapeoko enclosure 2" too short in the Y and Z axis. I thought I would be using a smaller Dust Collection hose and found myself with a 2.5" hose.

The attached models were made to hold the hose in place in a low-profile manner so the hanging hose doesn't get caught on the spoilboard or stretch and remove itself from the Sweepy.

Print the Z2Sweepy first and slip it into the Sweepy.

Print the Z Mount 2nd. You'll need slightly longer M5 machine screws to replace the original ones in the stepper motor. I believe I remixed this from PWNCNC's Stepper Mount for Festool shop vac hoses.
Here, you'll want to jog the spindle to the front right corner and lower the spindle plate as low as it will go - this gives you the longest stretch point. Give the hose 1" of extra travel length down then zip tie it to the Z Mount.

Print 2 of the X Mount brackets and place one on the far left of the gantry and one at the 7th screw cap on the linear rail of the gantry. Use a 3M poster strip to connect the brackets to the gantry.

What you'll need:
1 x Z2Sweepy
1 x Z Mount + 2 x M5x12mm + 2 Zip Ties
2 x X Mounts + 2 x 3M Poster Adhesives + 4 Zip Ties