定制专属肛门按摩器

Customized Anal Dildo

2024-04-02 23:11:17

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I wanted a knot, but the knot-dildos/knot-plugs available always had one of three flaws or all of them:

too thick, either shaft or knot or both.
too long, especially the part above the knot.
part between knot and base too short.

Also sometimes the part between knot and base was too thin.

So I designed this. Basis was a design on http://dildo-generator.com , but unfortunately there only perfectly axially symmetric parts a possible. That doesn't account for the forward bend I wanted for the part above the knot, and also a circular stopper is quite uncomfortable. So I did some modification of the basic design in Blender.

Quite important was the finishing. The surface was a bit rough at some places, which also would make the use a bit uncomfortable, for me at least. So I used Ethyl acetate (Essigsäureethylester/Ethylacetat), which I soaked a tissue in (wearing gloves: Ethyl acetate isn't poisonous as such, but can be taken in through skin and breathing, and is metabolized into acetic acid and alcohol/ethanol, so you can get "drunk" from it). Gently rub it over the rough parts of the surface, gives a great touch