普鲁萨 CW1/CW1S - IPA 染料过滤器持有器（标准H型滤器）

Prusa CW1/CW1S - IPA pigment filter holder for standard H-Type filter

2024-04-03 00:52:50

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This filter holder for Prusa CW1/CW1S is inspired by this Prusa Research model : https://www.printables.com/fr/model/462448-ipa-pigment-filter-holder

This design allows the use of standard H-Type pool filters (height = 10 cm, outer diameter = 9 cm, inner diameter = 3 cm).

It uses the "Filterholder bottom.stl" file designed by Prusa (see link above); This original file is distributed with this design.

How to use it (extract from Prusa documentation)

Firmware 3.3.0 and newer (recommended method)
Starting from firmware 3.3.0, the CW1/S has the IPA filtering option in the menu. This mode will spin in one direction for 40 minutes to filter the IPA.
Also starting in this firmware, the washing mode will spin in both directions. This direction change is not good for filtering, so do not use the washing mode to filter the IPA.

Firmware 3.1.0 and older
Firmware 3.1.0 and previous releases are not supported, therefore it is recommended to use release 3.3.0. In case you are unable to update, there is a unofficial and not recommended solution.
After inserting the filter assembly on the CW1/S tank lid, you can place the tank on the machine. In the CW1/S menu, go to Run-time -> Washing run-time, and set it to 10 minutes. Use this mode four times to filter the IPA (40 minutes in total).