WhoopDegen 案例

WhoopDegen Case

2024-04-10 17:32:30

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

The WhoopDegen Case holds:

2x 65mm whoops
15x 300mah lipo hv batteries
misc tools/props/prop popper
Whoopstor 3 charger & usb c cable

For latch and hinge hardware, M3 nuts and bolts fit well. I used random foam from boxes that drone parts have come in for the inside of the lid and the charger compartment so that everything is snug when the case is closed. This bad boy will eat up about half of a roll of PLA.

I combined the Frog Box 2.0 and DaLunchbox v1 in tinkercad to design this. Links to both below. DaLunchbox was stretched vertically so that it could fit more tools and 2 whoops. I also added a large compartment for a charger.

I wanted to be able to toss this around, plus, DaLunchbox only fit 1 whoop and the lid got very loose over time. The inside walls area little sloppy but was good enough for me.

https://www.thingiverse.com/thing:3110229
https://www.thingiverse.com/thing:4094861