RCM夹具固定架适用于Skull & Co Neogrip

RCM jig holder for skull & co neogrip

2024-04-12 21:37:19

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A clip to replace the one that comes with the neogrip that can hold an rcm jig.

The included stl has a deeper slot for the jig than in the photo, so that the jig sits more flush with the top. (I am on my last bit of filament and didn't want to use any to print it again)

I used this rcm jig designed by Sulya ( https://www.thingiverse.com/thing:2973594 ) but it should work with any jig out there.

Print Settings

Printer brand:
Anycubic
Printer:
Kobra Go
Rafts:
No
Supports:
Yes
Resolution:
0.3mm
Infill:
100%
Filament brand:
Sunlu
Filament color:
white
Filament material:
pla
Notes:
My printer is pretty bad so results may vary a bit with these settings. I would actually recommend a 0.2mm layer height instead.

Post-Printing

If you're going to sand this, make sure that you're careful with the small tab on the back that clicks into the grip itself, since it's very easy to sand off. I had this happen and used some electical tape so it fits with friction instead.