触手形热水器毛巾挂钩

Tentacle Radiator Towel Hook

2024-04-14 20:21:07

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Inspired by https://www.thingiverse.com/thing:6547513 but tentacle!

The Tentacle Bathroom Radiator Towel Hook

Radiator hooks are great, but the ones I found I needed to adjust to my radiator's measurements. -- Remixing the Skadis Tentacle Hook to fit was just as easy and it turned out nice, so here goes.

Designed to fit 25.4mm pipes with a 14mm gap. In the process I very slightly shrunk the model for a better fit, so this hook is a little smaller than the original tentacle. I highly recommend measuring your radiator before printing this.

Print Settings

Printer brand:
Anycubic
Printer:
i3 Mega S/Pro
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
15%
Filament brand:
unknown
Filament color:
black
Filament material:
PLA
Notes:
I have had good results printing tall and disabling supports for at least most of the suckers.

CAVEAT: I printed the first prototypes in PLA (because it's the only material I know how to print reliably right now) - I am not sure how well they will hold up to a hot radiator, but we will see when it gets colder again.

How I Designed This

My Blender Learning

I measured the dimensions of my radiator and added two cylinders representing them in blender.

Overlaid the tentacle hook and added a boolean difference modifier to remove the pipes from the hook.

Also needed to cut a tubular section from the back to allow mounting the hook without bending the pipes (too much). Fine tuning the model for your hardware will probably improve this aspect.