鲍登夹紧器的应力缓解

Bowden Clamp Strain Relief

2024-04-14 21:27:25

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Loved the original design but it seemed a problem with the clearances, at least with the cheap Bowden clamps I got from Amazon. My PLA was too fragile (mebbe too old) for the one I tried and PLA+ and PTEG too rigid for the tolerances of this design. Head of the Bowden clamp I had was nearly 10mm and this clip just wouldn't slide over. Added clearance for that head. Noted that the ID of the original design was just 4mm, the same as the the Bowden tube itself under the end lip. Enlarged the hole to 7.4mm so it would fit over the metal part of the clamp, then elongated that center so that the clip would be mostly centered on the Bowden clamp it was being installed on. Worked well with new PETG.