微缩树屋

Tiny Treehouse

2024-04-17 17:48:52

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Tiny treehouse
Made to fit a small dracaena.
you will need a glue gun and a wooden skewer.
I used toothpicks for the railings.

First I glued the sharp end of the skewer to the floor plate.
Then I placed the side structures in the slots. for me, no glue was needed.
Then I glued the structural beams to the skewer in the center with hot glue, trying to glue from the bottom so less glue is visible from the top.
After that I glued the roof segments with hot glue to the skeletal structure.

I suggest leaving the entire skewer complete to make painting or assembly easier, and trimming it once painting is done.

The open part in the floor actually fit tight enough for me so the tree house could hang without glue or console underneath.
I wouldn't suggest gluing directly on the plant. If the plant is too small, perhaps choosing the right section on the plant could help with the fit, or some 2 component putty could help with securing the tree house to your plant.

The bottom supports I glued on after securing the tree house to the plant.
Afterwards I wrapped some wool thread around the bottom supports, mainly for looks.

Print Settings

Printer brand:
Anycubic
Printer:
Vyper
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2mm
Infill:
5%
Filament brand:
generic PLA
Filament color:
up 2 u
Filament material:
PLA
Notes:
if you can fit more, it'd be nice to connect them to each other using rope bridges made with sticks and some thread.