DANA-i 胰岛素泵壳

Insulin pump case for DANA-i

2024-04-18 21:38:26

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

There are no cases for insulin pumps. We made a couple.

Increase the scale by 0,7% so to 100,7% for a better fit.
The hole is for additional safety to use a carabiner or similar tie-down to pants.
The photograph show a smaller previous version that we used for nylon for an earlier version of the pump to illustrate the general looks.

Position at 45 degree angle for structural strength.

Print Settings

Printer brand:
UltiMaker
Printer:
Ultimaker 2+
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0,15
Infill:
30
Filament brand:
FilaLab
Filament material:
PLA
Notes:
increase the scale by 0,7% so to 100,7% for a better fit.
The hole is for additional safety to use a carabiner or similar tie-down to pants.
The photograph show a smaller previous version that we used for nylon for an earlier version of the pump to illustrate the general looks.

Position at 45 degree angle for structural strength.