Mistral-E 组织导线冷却管道

I've owned my Ender-3 Pro V1 for 3 weeks now (as of this writing) and one of the first things that needed improvement was the filament cooling duct. The original isn't that bad but it doesn't blow the air where it's needed the most, concentrated below the nozzle. This is particularly important when printing overhangs and slim pointy objects.

Mistral-E design objectives:

• Use with original fan that comes with the printer.
• Blow high volume air on the filament just beyond the nozzle.
• Avoid getting any cooling air on the heater block.
• Designed to get the hot air away from the object as fast as possible.
• Create a version that is compact and will not interfere with auto level sensors.
• Reduce the noise level of the fan as much as possible.
• Make it as light as possible to avoid high mass on the extruder.

Attention:

• This cooling duct is intended for use with the standard unmodified Ender-3 or Ender-3 Pro printer.
• It is recommended that the cooler be printed in ABS or PETG as these filaments are more heat resistant.
• Pay close attention to the pictures so the position of the cooler is clear.
• Use a 2.0mm drill to clean up the screw holes for mounting.
• It is not recommended that this part be finished in acetone as this might warp the fan duct and thus degrade performance.
• I'm seeing people having a different fan compared to the one I have. Therefore it might be necessary to remove the two little thin supports.

TIP:

• Download the files only if you are going to start in printing the parts because I might have done some required design tweaks/changes which will be noted below as revisions.

It would be nice to post a picture with comments if you have made one.

Please support my work by giving me a tip if you find my Mistral-E design useful.

Thanks.

Leo

Revisions:

• 03.12.2018: V1.0 First public release (file removed).
• 08.12.2018: V1.1 Modified left and center channels (file removed).
• 29.12.2018: V1.2 Minor tweaks to the channels. Moved center outwards by 0.5mm. Added two additional mounting tabs.
• 27.01.2019: Very minor updates to V1.2.
• 05.03.2019: V1.3. Improved airflow spread.
• 04.01.2020: Added v1.3 with no support for those wanting to set support via slicer. Also added a version without small tab support for newer Ender-3 models with different fans.
• 23.02.2020: Removed file "with no support" because people are printing this without slicer support enabled = fail!
• 13.05.2020: Uploaded the step file for easier remixes.