传感器推杆固定架

SensorPush holder

2024-04-29 05:23:45

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

SensorPush make excellent temperature and humidity sensors that log data every 60 seconds and can then store it or send the data via bluetooth to your phone or via a gateway to the internet. This allows you to monitor your environment (Freezer temperature, home, 3D printing environment, etc) from anywhere in the world and receive alerts if temperature or humidity is out of limits set. Bluetooth range is exceptional. I wanted to monitor my camper van internal temperature and needed a holder for the SensorPush HT.w sensor.

I was inspired by the work done by 3DAllison https://www.printables.com/model/84038-sensorpush-ht1-mount and I wanted something similar, but suitable for 4mm self-tapping screws to mount it underneath a cupboard. This too is a slide in/out design and should be a gentle interference fit.

Print Settings

Printer brand:
Bambulabs
Printer:
Bambu X1C
Rafts:
No
Supports:
No
Resolution:
0.16mm
Infill:
15%
Filament brand:
Sunlu PLA
Filament color:
Grey
Filament material:
PLA+
Notes:
Best printed by standing it on its end. This avoids any overhangs although you may get some distortion in the screw holes. If the fit is too tight then just the scaling slightly to suit.