The Hive v2 - 无支撑骰子塔

The Hive v2 - Supportless Dice Tower

2024-04-29 05:37:40

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

About 2 years ago I designed this dice tower in Tinkercad because I wanted a support-less dice tower to print that would also allow you to watch the dice as they went through the tumbler. I've been wanting to make an improved version for a while and, this time using the Tinkercad code blocks, I finally got around to making that improved version!

This dice tower is still support-less but is both an aesthetic and functional improvement over the old tower. The steps are more defined to facilitate more tumbling of the dice while being slanted to make sure nothing gets stuck halfway down. One of the pieces of feedback I got on the old version was the lip was too shallow on the tray, which is something I have fixed in this version as well.

There is a regular version which is appropriately sized for standard dice, and the small tower is sized for mini dice (~10mm or smaller) ONLY.

This tower does not need supports but it does do quite a lot of bridging so make sure your printer's bridge settings are up to snuff. However it is easier bridging than the old version at least.

Recommended settings:

0.2 mm layer height - this is important for the hexagon detailing in the tray
4 walls
10% infill
ironing on with concentric pattern - this is a recommendation, and also very dependent on your printer, but for the tray versions, I find it is very helpful in getting that nice flat finish to keep your dice landing properly.

Also fun fact: The very first roll I made on my first prototype print was a nat 20.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 V3 SE
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
10%
Filament brand:
Inland
Filament color:
Translucent Rainbow 1
Filament material:
PLA
Notes:
Recommended settings:
- 0.2 mm layer height
- 4 walls
- 10% infill
- ironing on with concentric pattern