eGPU外设机箱设计用于UT3G

eGPU enclosure for UT3G

2024-04-29 21:00:22

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Poor man's eGPU enclosure for UT3G

It's designed for:
-ADT link UT3G eGPU
-small GPU cards like single-fan RTX3050 from Palit
-standard size ATX PSU
-3D printer with 15x15x15cm printing area

Print:
-4 main parts of the shell
-one grill ring
-2x lock rings
-3x locking clips

Print orientation for shells showed on screenshots
-Start assembly by temporarily unscrewing rubber foots from the PCB
-slide PCB to the bottom-connector-side part.
-slide other bottom part
-screw in rubber feet again and put one more screw with nut in the additional empty hole
-install plastic clips (slide in on the fitting part inbetween shells
-plug USB cable (exit hole is just under the PSU - rectangle hole)
-install GPU
-Install PSU and connect power cables
-assemble separately top shell using same plastic slide-clips and you can already screw the grill-ring
-install top shell to the bottom-shell
-install lock-rings (just twist them) and remember to put all of the screws

Part-to-part gap is set as 0.4mm, depending on your printer and calibration your mileage may vary with the fitting.

THIS IS A PROTOTYPE, NOT TESTED YET as it takes a lot of time to print for me
The cable holder/clip to fill in the USB hole and hold cable better - TBD