德隆奇精华小杯大型模版款

DeLonghi Essenza Mini Large Cup Mod

2024-05-05 15:56:39

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发货），感谢理解带宽压力

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

NOTE: This willnotfit theBrevilleEssenza Mini, which has a different front profile.

Our 13 year old(!) DeLonghi Latissma+ finally bit the dust, and we replaced it with a smallerDeLonghi Essenza Mini.

However we quickly discovered that most of our coffee cups were either too tall or too "bowl shaped" to be used with the new machine.

To deal with this I designed a replacement set of parts.

The primary changes are a low profile cup drip tray with a larger base to accommodate taller, wider coffee mugs, and a "bowed in" front profile to allow some of our mugs to be in far enough to go under the outlet spot.

Because the parts have some unavoidable overhangs due to how the original parts are designed to fit into the machine,you will need to enable supportsfor...

CupDripTray
- Automatic supports should be fine - I used Orca Slicer'sType: Tree,Style: Tree Hybrid
CapsuleDripTray
- Automatic supports should be fine - I used Orca Slicer'sType: Tree,Style: Tree Hybrid
UsedCapsuleCatcher
- Automatic generates alotof unnecessary supports, so I'd recommend doing it manually and select only the area shown in the images. - I used Orca Slicer'sType: Tree (Manual),Style: Tree Hybrid

Make sure you print theCupDripTrayGrill"upside down" so that the top side is laying on the print bed - the STL version of theCupDripTrayGrillis already in the correct orientation.

Print Settings

Printer brand:
Bambulabs
Printer:
Bambu X1C
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
15%
Filament brand:
3D Fillies
Filament color:
Black
Filament material:
PLA+
Notes:
As noted above,you will need to enable supportsfor...
- CupDripTray
  - Automatic supports should be fine - I used Orca Slicer'sType: Tree,Style: Tree Hybrid
- CapsuleDripTray
  - Automatic supports should be fine - I used Orca Slicer'sType: Tree,Style: Tree Hybrid
- UsedCapsuleCatcher
  - Automatic generates alotof unnecessary supports, so I'd recommend doing it manually and select only the area shown in the images. - I used Orca Slicer'sType: Tree (Manual),Style: Tree Hybrid
I also originally thought that I might need to use ABS because of temperature concerns, but so far the PLA+ holding up just fine.
While designing this I printed a few iterations in draft mode with 0.3mm layers, single walls and only 10% gyroid infill - they seemed to hold up just fine over the course of a few weeks before I printed the final version in black. If you're looking to save some plastic, you might want to give this a try instead.