武装骑士OOO奖章边缘混音版3D模型

Kamen Rider OOO Medal Rim Remix

2023-05-08 07:03:23

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

摘要

这是对来自这里 . In the original version, you need to print two of the 核心 medal rims and glue them together to put the 前沿 and backs in, but I wanted a version w这里 the rim was a single piece that you could snap the 前沿 and backs into. So 这里 it is!

我的奖牌边框混音尺寸适合大部分奖牌前沿 in the link above as they are. The medal backs are smaller, and should be sized up 200% on the X and Y, but NOT Z. (I think some of the bird medals are also the same size as the backs and should be sized up to 200%.) I also found in my printing that to ensure friction fit, the 前沿 of the medals may need to be sized up to 100.5% or 101% on the X and Y. (TLDR, the X and Y for the 核心 medals and backs should be around 36.5mm in your slicer for a proper friction fit. If they come out a touch too small for the rim, you can glue them together without much issue.)

I am not sure if t这里 is still enough clearance to install rfid's and use these with the scanner, so if that's something you're concerned with, experimentation may be needed.