维基思控制器支架（用于Lucid VR手套）- 修改版

Vive Controller Mount for LucidVR Gloves - Modified

2023-05-11 22:32:02

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I printed of the original and found the clamping pressure a little lack and the mount was far too thick.

On the bottom part the slider rails are 2.5mm, the gap it fits into is only 1.70mm to 2.20mm wide, along with this I gave it similar geometry on the bottom as the LucidVR pot sliders.
The top part where the controller sits I took off 2mm to get better clamping force.

On the screw part I shorten by 2.5mm to compensate for the change.
I also remove the text to simplify the print.

Print Settings

Printer brand:
UltiMaker
Printer:
Ultimaker Original
Rafts:
No
Supports:
Yes
Resolution:
0.06mm
Infill:
35%
Filament brand:
eSun
Filament material:
PLA+
Notes:
Supports:
only needs supports on the 90 degree over hangs to get a tidy print

Orientation:
Internal thread part on the bottom part pointing up
Thread pointing down on the top bolt part.

Post-Printing

Clean up of the print

It will need a clean up of the thread and will be tight but once all the obstructions are cleared from the internal tread it goes smooth.

Clean the end of the bolt part so it will engage with the internal tread.
Get it started and work it back and forth, backing it right out and tapping it on something hard to get the debris that has come free, out, repeat until the thread goes in all the way.

Watch out for elephants foot as it will stop the bolt from going in.