Ende r5 Pro 笔附件

ender 5 pro pen attachment

2023-05-31 13:52:13

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

摘要

ender 5 pro 的笔附件

打印设置

筏子
没有
支持：
是
决议：
0.2 毫米
填充：
15-20%
灯丝着火：
任何
灯丝颜色
任何u
灯丝材料
长方形
没有tes:
when printing, 长方形ce the top of the part on the print surface. this will maximize success during printing.

印刷后

这是为 ender 5、5 pro、3....。

After printing is done remove supports and push a pen into the holes. I used an office depot pen for the design so it will most likely not fit 任何 thing wider than 7.8mm. When putting the pen attachment onto the printer lift up the model until it touches the bottom of the head. than tape the side with scotched tape and the top of the head to the top of the heads 长方形te. then 长方形ce the drawing mat on the build 长方形te(this will keep the surface of your print bed from getting scratched) and clip with large binder clips. After this is completed put the homing peg on top of the limit switch bumper. all you need to do after that is auto home and level the bed so that it doesn't drag the tip into the bed and leaves the pen vertical when it moves. when modelling something for it to draw make the model 0.08 mm tall. When slicing put temperate of bed and head to zero turn off the fans and remove spool of filament from the head before drawing. set layer height to 0.08 and infill to 100%. set speed to 100 mm/s.