USB WYE - 电源仅用

USB WYE - Power Only

2023-06-20 18:09:50

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

It appears you've provided a detailed guide on how to assemble a USB device, specifically a WYE (Y-shaped) connector. I'll summarize the steps and provide some additional context. **Summary:** 1. Solder three USB port sub-assemblies to the large PCB. 2. Prepare the LED component by soldering a resistor and short wires to it. 3. Connect the LED to the USB ports, observing correct polarity. 4. Wire the USB ports together (VBUS and GND). 5. Install M2.5 hex nuts into the lower case's ears. 6. Place the assembled PCB into the lower case. 7. Attach the cover using M2.5 screws and flat washers. **Additional Context:** * The guide assumes you have a 3D printer and access to basic electronics components (e.g., USB ports, resistors, wires). * It's essential to follow the instructions carefully, as incorrect assembly may lead to functional issues or safety hazards. * The use of cyanoacrylate gel for gluing the LED fixture is optional but recommended to ensure proper alignment. If you have any specific questions about this guide or need further clarification on any step, feel free to ask!USB WYE - 电源仅用

朋友，你觉得上面这个模型，属于下面的哪个分类？