Corsair 465 RGB 120mm GPU风扇护罩

Corsair 465 RGB 120mm GPU Fan shroud

2023-06-22 16:07:16

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This GPU Shroud was made for Corsair 465 RGB Case. The shroud is a simple placement application. No Hardware or Tools needed. It Simply sits in between the bottom 120mm fan and the bottom Shelf

Print Settings

Printer brand:
Creality
Printer:
Ender 3
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
Any (Lowest best, saves time and filament)
Infill:
2%
Filament brand:
eSun
Filament color:
Black
Filament material:
PLA
Notes:
This GPU Shroud was made for Corsair 465 RGB Case. The shroud is a simple placement application. No Hardware or Tools needed. It Simply sits in between the bottom 120mm fan (Any fan thicker than 25mm may not fit, 25mm is the standard fan thickness) and the bottom Shelf.

Purpose of it was to make use of the bottom 120mm fan more towards the GPU rather than the hard drives located in the PSU Segment of the case (Since I don't use any internal hard drives).

This has proven useful as the GPU (my case was a Powercolor RX 6800) to be even idling at 5 Degrees cooler and dropping the Junction temp from previous 95 Degrees (Within safe margin but a little too toasty to my liking) to 85 degrees whilst maintaining same power draw and GPU Clocks.

It Will require during the print to use very little infill, and definitely will need supports as the ducting is hollow to allow the air to smoothly flow into the outlet.