龙在囤积你的剪刀

Dragon that hoards your paperclips

2023-06-23 05:08:56

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

The desktop dragon returns! This time hoarding your paperclips. This model was built from Dragon that hangs on your monitor, and I edited it in a few ways that should make it easier to print in one piece.

Because the base is magnetic, your dragon isn't limited to hoarding paperclips. Key rings, small metal parts such as loose screws, and hairpins can all be added to the hoard as well. Any magnetic shinies, really.

As before, I've included a few different versions of the model - with and without wings, as well as a 3-piece version with the wings separated, for greater flexibility with printing. I printed these as one piece, and got pretty good results every time I tried, so that's probably what what I'd recommend doing. You will have to remove a lot more supports if you try to do it that way, however.

There are two pegs coming out of the base that fit into two slots in the underside of the dragon, and one hole on the bottom of the base for a magnet to be glued in. The magnets I had were about 14mm (~½") in diameter, so that's what the hole is sized for.

The finished model of the dragon is about 8*7*3 cm (~3¼*2¾*1¼ inches), and the base has a diameter of 10 cm and a height of 1 cm (~4" dia, ~½" thick). The model in the photo is a bit larger, as it was printed at 115% scale.

I have also included both the source .blend file for the dragon as well as the source .SLDPRT file for the base, in case others want to modify it. If you do, take care not to move the pegs relative to each other in one file without moving them by the same amount in the other.

Print Settings

Printer brand:
Creality
Printer:
Ender 3 Pro
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.12 mm (dragon), 0.2 mm (base)
Infill:
15%
Filament brand:
Eryone
Filament color:
White + Black
Filament material:
PLA
Notes:
Supports are required for your print to come out looking nice. I recommend using the organic style of supports found in the newest edition of PrusaSlicer, as they're the easiest to remove and they don't mark up the surface of the model too much either.

My printer has a tendency to knock over taller supports when the print head moves past them, so I always have a zhop of at least 1 mm set, But your results may vary. This gives me more safety during prints, but also results in making a bunch of tiny hairs come of the model, which I need to trim at the end.