3rd代卡马罗杯冠军

3rd Gen Camaro Cup holders

2023-06-23 05:57:41

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

The Center console cover designed for a 91 Camaro should fit 82-92. The cupholders are sized to fit standard 12 oz cans and small bottles. the installation can be challenging and did require a small amount of trimming of the lower console components. when printed with a textured bed and proper supports it can look very consistent with the other interior components.
NOTE: The shifter opening has been repositioned 10 mm further back in the car. if this causes a problem getting into first there are provisions to remove the factory retaining plate from the boot and then use binder clips to hold it in place.

Print Settings

Printer brand:
Creality
Printer:
Ender-3 v2
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
10%
Filament brand:
Hatchbox
Filament color:
Black
Filament material:
PLA+
Notes:
I used PLA+ because the southeast and the car is heavily tinted so the heat is not that bad. however, PETG or ABS would be better suited to prevent warping or sagging if you expect high temps inside the car when it is left sitting in the sun.

I used an Ender 3 and had to cut the model into 2 sections and bond it back together.