Delkin 脱脂山地虎稳定器 - 45°

Delkin Fat Gecko Stabiliser - 45°

2024-04-06 22:36:35

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a stabiliser mount for the Delkin Fat Gecko camera mount.

This is designed to hold the camera mount steady at 45° - As I found when using the mount, it would easily become loose with use, especially over bumps.

Print Settings

Printer:
CTC Bizer Dual (MakerBot Replicator Dual clone)
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
60% Hexagonal, 0.2mm layer height
Filament brand:
Enotepad
Filament color:
Black
Filament material:
PLA+
Notes:
4 shell layers. Best to print flat.

I used approximately 13g of PLA+ for this print.

Post-Printing

Step 1

Remove from print bed.

Step 2

Place the base of the mount (identifiable, being the OPPOSITE side of the zip-tie holes) into the stability arm of the Delkin Fat Gecko.

Step 3

Lower the mount arm of the Delkin Fat Gecko onto the stabiliser. Grab a zip-tie and thread it around the mount and through the holes in the stabiliser. Tie it tightly. It will be ready for use.