可携带碰撑盒子3D模型

Portable Hitbox Case

2023-06-23 17:44:13

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a remix based on Thomas-Star's portable hitbox case (https://www.thingiverse.com/thing:5460468). The starting base is Thomas' smaller model that uses traditional hitbox button size and since it was smaller, was able to fit on the bed of my Bambu Lab P1P.

Changes made I made:

Increased the model height to 36mm to accommodate 24mm buttons on the sides
Replaced the four 12mm holes with two 24mm holes and rounded out the case
Added two 24mm holes on the left side
Rearranged action buttons for a Vewlix layout
Increased the USB cable routing hole to 5mm to accommodate a larger variety of cables such as the AmazonBasics USB-B to USB-A cable

Even though the model was raised, you may still need to bend the pins on your buttons. For Sanwa buttons, you will need to bend them for sure.

I was able to fit a Brooks Zero Pi board into this case, but it was an extremely tight fit for the 4-pin JST connector that connects to the L3/R3 buttons. If using an Arduino or RP2040 there should be no issues with fitment.

Use M3 x 10mm screws to screw in the bottom panel. Add rubber feet of your choice.