被囚禁神灵的遗迹 - 冰天之城的BOSS

Vestige of the Imprisoned God - Frosthaven Boss

2023-06-27 17:37:12

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Back story:
I decided to try my hand at making the "Vestige of the Imprisoned God" (Frosthaven boss), since I couldn't find any designs for it. If you end up printing it, I'd love to hear from you in the comments, or see your make, so I know my time has somehow benefited others :).

Design notes:
Its a relatively simple design, despite taking me two full days to make and repair... I wanted to add the symbols and other markings shown in the artwork, but that's beyond my current skill level, so you'll just have to paint them on :P.

My original design ended up looking a little too thin for my taste, so I adjusted the dimensions to make it appear a bit more formidable. The "small" is 10cm tall (seen in the photo with the drifter and snow covered trees), and a bit thin. The "normal" is also 10cm tall, but has a thicker body. The "large" is 12cm tall, and also has a thicker body; it's also the one I will likely use when/if my party faces the monster. All three have a 30mm base diameter. I added a photo with all three, next to the Brute, for size comparison.

Print notes:
I sliced the model in Lychee, and try as I might, it always says there are errors which cannot be fixed... Thats somewhat irrelevant though, as it printed perfectly every time. It would probably print fine without supports, but i still added a few along the overhangs. Just make sure that the base of the supports don't connect with the base of the figure.

Misc notes:
If it doesn't print correctly for you when sliced in Lychee, let me know and maybe I can put a bit more work into fixing the mesh.