神灵2遥测装置

Deus 2 Remote Case

2024-01-05 10:12:04

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is an alternate case design for the Deus 2 remote. It consists of a mounting plate with small supports to hold the remote in place. A cover is attached to the plate using studs and thumb nuts. If desired, a sun shield can be attached to the cover with glue or double-sided tape to reduce glare on the remote’s screen.

The supports are printed as separate items and then glued to the plate. The left hand and right hand plates angle the remote's display approximately 15 degrees toward the user's face. The straight plate aligns with the Deus shaft.

M3 x 10 mm long screws are glued into the cover to act as studs. The cover is secured with M3 thumb nuts. This method was chosen for simplicity over the use of M3 threaded inserts which are manufactured in numerous shapes and lengths.

The remote fits on the center support as shown in one of the photos. With the cover in place the remote will barely move. Attaching the antenna clip to the remote, even if the antenna is not installed, will secure it even more.

If the antenna is wrapped around the Deus shaft, it can be routed through the lower hole on the right side of the plate. If the antenna is run inside the Deus shaft, it can be routed through the hole in the mounting plate stub.

The plate is attached to the Deus shaft using M3 x 8 mm long sheet metal screws. Pre-drilling 2 mm diameter pilot holes is recommended.