桌子夹杯架，7cm和6cm直径

Table Clamp Cup Holder - 7cm and 6cm diameters

2023-06-28 03:57:54

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Back story:
I wanted drink holders for my gaming table, and I really liked the robust and simple design of the original, but the 8mm ring was too large for some of my glasses.

Design notes:
I made the following changes...

I altered the original cup ring down from 8cm to 7cm, and again to 6cm (both are included).
My table has a lip underneath, so I also shortened the clamp so that it would slide all the way to the lip. I wanted as much of the clamp touching the table as possible, for increased stability.
I decreased the height of the clamp, as it wasn't necessary for the thickness of my table.

Printing notes:
I printed it flat on the build plate, as well as tilted and supported, both worked fine.

Misc notes:
Keep in mind that due to the split in the ring, heavier glasses cause it to "open-up/expand" a bit, causing heavy glasses to "sit" lower. I printed 6 sets with 7mm rings and they works great for my needs (all the photos are with the 7mm ring).