保护你的（FDA）可以！

Cover Your (FDA) Can!

2023-07-22 11:12:01

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

My other Foil Drive printable parts:

Print Instructions
Typical print options should work: 20% infill, no adhesion, no supports. Overhangs are 45 degrees or steeper (Prop Cover only), so no supports should be needed. Also, consider drilling a few air holes (see additional notes on this below).

Description
Protect your FDA motor and propeller assembly with these 3 covers. (Clean and dry your system first, as recommended in this Foil Drive video.) Keep the dust and dirt out. Protect your propeller from falls and drops.

The FDAPropCover protects your propeller from dings, falls, etc. Align the 4 "pads" at the mouth of the cover to slide past the blades. The pads should provide a reasonable friction fit on the hub shoulders (though I wouldn't go carrying it around by the cover alone).
The FDACanLid protects the other end of your propeller can. Slide it on to to keep dirt and dust out when your pod is disassembled. It should provide a similar friction fit.
The FDAMotorCover (orange part in photos) will similarly protect your motor while it is disassembled.

IMPORTANT
The last thing we want to do is trap moisture in the motor with these covers causing your FDA to rust. Clean and let your motor parts air dry fully before covering. You may even want to drill a few small air holes. I will consider adding a v2 with printed air holes in the future.