无人机飞翼支撑结构3D模型

RC Plane Wing Support

2023-07-23 11:55:48

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

REQUIRED FOR ASSEMBLY:
M3x15mm screw
M3 hex nut
ALTERNATIVE: Any 3mm axle will do

2.5-3mm skewer (bamboo skewers from kroger, diameter is about 2.9mm on my calipers)

I wanted a support for my foam plane wings that was fairly low profile, lightweight, and adjustable so I didn't need to print different angles or lengths.

I had about 2,000 3ishmm bamboo skewers so I just sized the hole for that. There is a small amount of play to allow for glue, if your printer has an expanded first few layers (elephant's foot) you may need to chamfer the hole a bit.

Cut the skewer or 3mm carbon rod to the correct size, and do a dry fit to get the angles and placement correct. use whatever glue you prefer to make it all stick. There are tiny reference holes I use to drive 1mm staples through the foam. You may be able to ream it out to an m2 screw but I have not tried this.

To lock the pieces together once you find the right angles, just tighten the screws slightly, not too much since it is a thin 3d printed part. I like to loosen them back up slightly so allow for small movements during flight.