HOMEMADE PIG STRETCHER
HOMEMADE HOG STRETCHER
使用说明
- 所有模型资源均由用户上传分享，内容来源于网络公开资源
- 侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
- 模型将通过邮件发送（5分钟内自动发货），感谢理解带宽压力
关于费用
我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！
扫码手机访问
抖音私信 @jobsfan
Summary
This is an old version of the Hog Stretcher.
Find the latest Hog Stretcher pre-made at https://HonestPE.etsy.com/
Print settings:
Use 0.12mm layer height for the ruler/bearing piece so that the markings will be visible. Use arachne mode as well so that it will be the correct thickness. After printing, rapidly move this piece up and down the rod to wear down/remove any irregularities and ensure smooth motion.
Here is a complete list of the parts you will need:
mcmaster:
316 Stainless Steel Corrosion-Resistant Compression Springs x2 ($8.82 for 2)
https://www.mcmaster.com/8969T811/
Passivated 18-8 Stainless Steel Pan Head Phillips Screws x2 ($6.68 for 10-pack)
https://www.mcmaster.com/92000A526/
Tapered Heat-Set Inserts for Plastic x2 ($13.06 for 10-pack)
https://www.mcmaster.com/94180A386/
amazon:
Gas Spring End Fitting M6 Female Thread 8mm Hole ($11 for 2-pack)
https://www.amazon.com/dp/B09B7G1QRY
Threaded Heat-Set Inserts Brass for Printed Plastic Parts M6 ($11 for 20-pack)
https://www.amazon.com/dp/B09ZNW4PC9
Fully Threaded Rod M6 x 300mm ($9.49 for 2-pack)
https://www.amazon.com/dp/B0BLGML4MW
M4 Hook Bolt 304 Stainless Steel Screw in Hooks ($7.59 for 10-pack)
https://www.amazon.com/dp/B08CCZYL5T
see the remix source for specific instructions on putting together. note that not all hardware parts from the original are necessary (e.g. the screw-in hook screws directly into the knob).
License
HOMEMADE HOG STRETCHER
by joooj is licensed under the Creative Commons - Attribution - Non-Commercial license.
相关内容
联系我们
最新模型
-
3D打印机导线存储架2024-05-08 -
ASG CZ 75 D 双方匣子保护罩2024-05-08 -
打印式面板 - 盒连接器2024-05-08 -
Radion XR15 支架2024-05-06
最热下载
-
3D机器人手臂模型2023-03-26 -
3D打印斯特林发动机型号Alpha2023-03-26 -
3D模型：Easier Print LTT螺丝刀拉拔器2024-01-14 -
奥迪奥技术卡 ATH-M40x 连轴器2024-03-23 -
厨房水槽滤网过滤器2025-06-05