OLED屏幕 Nintendo Switch 壁挂架

OLED Nintendo Switch Wall Mount

2023-07-25 20:48:41

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Remixed to fix a few issues I had with original.

*Updated 8-2-23
Realized the wire hole I added did not work out when I went to put mine on the wall, edited it to fit most HDMI plugs as well as moved to the correct location on the back of the dock to easily pass wires down/through.

Added a wire hole
Widened screw hole and head hole to 4mm - 8mm respectively to allow for most drywall screws, including the ones I will be using to mount this.
Added some vent / holes to lessen material usage
Corrected internal measurements to be 175.4 x 50.75mm
Fixed a weird gap / slice down the center of the mount
Added a way to way hide wiring should you need to go left/right once out the wire hole, this bottom mount uses 2x m3x20mm button head screws. There is also an end cap and Arrow on the inside of the tunnel, arrow faces the way you want the wiring to go, end cap goes on the other side. I was going to make it fixed but realized someone may want to put it on the other side instead. May upload a condensed version of this later.

Obviously can be printed without the wire channel.

I believe that is all I have done to this.

I printed using White PLA at 40% infill just because.