沃克斯机械的传奇 - 坏消息

Legends of Vox Machina - Bad News

2023-07-27 00:57:57

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Never apologize for being a genius when you have Bad News with you.

This is based on screencaps taken directly from The Legend of Vox Machina and is strictly a prop. The barrel is probably a little wider than it should be but overall I'm happy with how it turned out. The picture is before any patching and painting take place. Be gentle with the trigger mechanisms as they are fragile. This gun does not fold like in the show.

Everything should be glued together with adhesive of your choice.

To assemble we will start at the bottom.

Put Gold Trim Stock piece over Bottom Stock.
Place upper stock over gold trim and bottom stock
Add Triggers to bottom of upper stock
Place middle piece on top of upper stock

For the barrel: Barrel1 are the middle pieces of the barrel. Barrel2 parts should be added at the beginning and end of the middle pieces.
Barrel3 slides into the very end of the barrel with the notch going to the back of the gun.

Slide the barrel with the notch going between the "wings" of the middle piece.

Add the hammers and the circle pieces to the middle piece and barrel as seen in the image.

The triangular sight goes on the end of the barrel with the hole along the ridge. I did not add a lens to the triangular sight as it would be easily broken off.

The four lenses slide into the circular sight slots and are for appearances only. They do not pop out like in the show. Glue the the circular sights on Barrel 3 ahead of the "wings" of the middle piece.

Barrel stock is glued beneath the barrel with the curved piece matched up against the middle piece. The tapered end goes towards the end of the barrel.

The barrel stock pieces are thin but seems to be in proportion with what I saw from screencaps of the show. I did not add the rod at the end of the barrel stock pieces as I was worried about it snapping off.

I know the stock of the gun looks strange but it prints well and eliminates seams so I didn't have to and paint that part.. I used brown and gold filament and I like the end result.

Also I know nothing about guns so if I got the parts wrong, don't @ me.