太阳能电池板或LED灯板小型持有者

Solar panel or Led panel holder - Small

2023-08-04 17:43:58

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I used the Customizable Ball Joint by kijja as the pivots. I'm open to improvement suggestions.

I used 30% infill for most parts. The small_solar_panel_threaded_ball_joint_ball_12mm_3.4mm_hole_x_7.5mm_upperhole for_4mm_bolt_head.stl, I used 100% and 45 speed. Then tap M4 threads into it. A M4 25MM cap head screw threads into the ball.

You could just use the ball joint to panel piece and just glue it to the solar panel without the adjustable frame.

Debur the parts after printing. The sldes are slightly siff at first but loosen up after working them back and forth.

I made the main slider in two parts to make it easier to print. You will need to glue the two pieces together:
small_solar_panel_sliding_frame_lower_140mm_bottom_1a.stl
and
small_solar_panel_sliding_frame_upper_140mm_top_1b.stl

Tap the holes in the sliders to M3.

I used 8 M3 x 6mm screws to hold the sliders down (finger tight +)

There are also stl files for a M6 threaded ball and M6 threaded turn buckle

Print Settings

Printer brand:
Creasee
Printer:
Creasee CS30
Rafts:
No
Supports:
Yes
Infill:
varies
Filament brand:
choice
Filament material:
ABS
Notes:
I used 30% infill for most parts. The small_solar_panel_threaded_ball_joint_ball_12mm_3.4mm_hole_x_7.5mm_upper_hole_for_4mm_bolt_head.stl, I used 100% and 45 speed. Then tap M4 threads intp it. A M4 25MM cap head screw threads into the ball.

You could just use the ball joint to panel piece and just glue it to the solar panel without the adjustable frame.

Debur the parts after printing. The sldes are slightly siff at first but loosen up after working them back and forth.

I made the main slider in two parts to make it easier to print. You will need to glue the two pieces together:
small_solar_panel_sliding_frame_lower_140mm_bottom_1a.stl
and
small_solar_panel_sliding_frame_upper_140mm_top_1b.stl

Tap the holes in the sliders to M3.

I used 8 M3 x 6mm screws to hold the sliders down (finger tight +)