Minisforum EM773 改进版空气流动底板

Minisforum EM773 Improved Air Flow Bottom Plate

2023-08-07 17:33:02

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Some members over at reddit in the MiniPC's channel have the nice EM773 AMD based system, but many talk about heat issues from the SSD and/or DDR5 SODIMM's. Although my personal unit has been fine, I thought I would contribute to the cause and design/print a revised bottom plate that offers:

A. Better air flow via the perimeter vents.
B. Making the plate a littler thinner (which will perform based on material used)
C. Removed the need for the two larger corner factory sticker feet that are annoyingly self destructive when removed to access the case screws. The feet are now made to be similar in size and use (round button sticker rubber feet (10mm x 5mm).

Although printing this face down may be the most obvious, it will produce week edge tabs, which was the case for me. Therefore, I suggest printing it flat side UP with the fastener shaft legs touching the hot bed. That means a lot of support material, but if you keep is on the less dense side with no support walls, it will help and end up making a better finished print.

Enjoy -