热带车4车展示盒

Hot Wheels 4-car Display

2023-08-07 17:34:29

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Here is a 4-car Lift style car display for Hot Wheels, Matchbox, and other 1/64 die cast cars.

Each lift pad is 80mm long and the tire pad width is 35mm. (Most of the Hot Wheels I sampled to be about 30mm wide at the wheels.)

Assembly should require no tools, but in case your printers isn't dialed in perfectly, a small file should be the only thing needed.

A note about usage:

If your display is only going to be for exactly that, for display and will not be used heavily such as for play scenarios, then there is no glue or adhesive required. The 4 lift pads add enough structural rigidity that it will hold up by itself.

I would recommend some adhesive (such as E6000 for the assembly if the display is going to be experiencing a lot of play time. This will help make the structure much more rigid and wont have the lifts moving and getting off-kilter. just a couple dabs on the outer edge/face of the lift pads arms should be more than enough.

Printing notes:

Prints with no supports with the tops of the lift pads facing down and the Lift posts with the open end facing up. I recommend 100% CONCENTRIC infill for rigidity but would not go less than 50%. My preference would be 100% concentric infill but if less, then pattern should not matter.

A slower speed is recommended as well due to the thin nature of the lift arms and thin walls of the lift posts. Higher speeds can be used if your printer has great bed adhesion.
I started with 50mm/s speeds max and 20mm/s for my initial layers and fine tuned from there for my printer. Leave part cooling fan off for first 3 layers.

Designed in FreeCAD, Sliced with Cura, Printed with AnyCubic Kobra.

Print Settings

Printer brand:
Anycubic
Printer:
Kobra
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.1mm/layer
Infill:
100
Notes:
If using 100% infill, the best pattern will be Concentric. 50% infill or less is not recommended. Pattern will not matter too much below 100%.

I printed with a skirt support, but no brims/skirts/rafts are needed. Skirt is just personal preference.

Layer height does not matter much. I would not print in more than a 0.3mm layer height though.

Printed using a 0.4mm nozzle