动力驱动式平台支撑架

Motorized Platform Jack

2023-08-09 03:09:07

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a remix of the "Platform Jack" to make it completely motorized. This is a fairly simple and cheap project with little prior knowledge of electronics needed.

Video: https://youtube.com/shorts/DoBgDl5bbw8

You will need:

AA battery housing(2x)
Standard Carling Switch
Small DC motor(I used the 50RPM which takes it about 30 seconds to fully extend and in my opinion it is a little slow. The higher RPM motors should fit this as well) https://www.amazon.com/gp/product/B082GNPTCS/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&th=1
20g wire

Assembly:

-Put the switch in the 'CONTROLS' Box and the motor in the 'motor mount' before you start connecting wires
-On the switch, connect terminals 1 and 6 to one terminal of the motor and 3 and 4 to the other.
Switch Diagram:
1 4
2 5
3 6
-Connect your batteries together in series and then to terminals 2 and 5
-Make sure to test the switch to make sure your motor is turning in the right directions.
-Use a Dremel to make a slot in the knob of the 'Platform jack' to accept the 'shaft connector'
-Put the 'shaft connector' on the motor and attach it to the knob on the 'Platform Jack'
-Insert batteries

Powder graphite works great to help the screw move more freely
All exposed wires should be covered

Print Settings

Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20
Filament brand:
Ender
Filament color:
Gray
Filament material:
PLA
Notes:
Supports used to print this but I believe it can be printed without supports.