Ryobi草除机P2008维修及零部件

Ryobi weed trimmer P2008 repair and parts

2023-08-09 07:08:39

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

The deflector of my Ryobi weed trimmer broke off from the motor base due to fatigue.
I have made an adaptor ring that fit the deflector and can be secure with screws to the broken section of the motor head. I have also included a spool retainer cap.

The cutter support plate will need to be grinded down a few milimeters to compensate for the thickness of the new ring. Otherwise the wire will not be cut at the proper length. I used a die grinder to slowly removed material from the support and front edge of the deflector in that area. The ring could also be scale down in the z axes to make it thinner.

To install the ring the motor housing will need to be opened in order to hold on to the shaft to removed the cutting head. Then partially reassembled to drill the holes a the right location depending of the amount o material left on motor flange. Once the holes for the screw have been drilled. The motor housing will need to opened once again to reinstall the cutting head. At this time the ring should be loose between the head and the motor housing before you close it.

These last two versions of the trimmer spool retainer cap have been updated with improved tolerance to make them easier to remove and install. the main difference is a small increase in the bottom thickness with version 07.