导线存储柜模型

Filament Storage Cabinet Model

2023-08-19 10:40:09

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Edit:
Just an fyi, I've noticed that there is a slight difference inside the cabinet for temp and humidity. I have 4 hydrometers, basically one in each corner. The top is hotter, obviously, and dryer. About a 5 to 10% different. I'm going to add a small usb bower fan in the upper corner blowing down. This should create a circulation to even everything out. I almost wonder if mounting the dehumidifier towards the bottom would have the same effect as it has a fan for circulation.

This is a sealed cabinet I build to store my filament rolls. It uses a dehumidifier and desiccant boxes to keep the material dry. I used 1/4 x 3/4 foam weather stripping for the doors, which is in the model, and standard hinges from Home depot(linked below). I spaced out the hinged just under a 1/4" so it left room for the foam seal but still enough to have a little compression. You can see these 3 pads behind the hinges in the photos.

The model has the door latches as well. These were 3d printed and use a RC Car suspension spring. Just something I had lying around. These could easily be modified to work with a different size spring. But they were from a Traxxas 4x4 Rustler rear suspension.

Here are links to the items I purchased.

Dehumidifier

https://a.co/d/eyBQfHl

LED Lights

https://a.co/d/0razsDQ

Magnets for desiccant boxes

https://a.co/d/3Npowy1

Hinges

https://www.homedepot.com/p/Liberty-Satin-Nickel-Self-Closing-Overlay-Cabinet-Hinge-5-Pairs-H0103BL-SN-U1/202824473