Gilmour洒水器顶棚模式主管早期型号3D模型

Gilmour Pattern Master Sprinkler Hood early models

2023-08-21 08:29:33

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Remix of the one Jester444 made. I found his did not fit my pattern master. I think they changed the design on the later models. The sprinklers I have are at least 15 years old maybe more. His has more flourishes. I made these fast to print and still work well. Reuse the stock spring. Print it upside down without supports. I added a ramp to one side on the pivot pin. On the older pattern master there are two sets of pins on the sides of the sprinkler. You need to cut off the rearward ones before installing the hood. Once you remove those pins install the hood by put the spring in place on the hood then locate the spring on the sprinkler. Then align the pin on the side without the leg. Then simply press down to press the pin into the ramp and snap into place on the other side.

If you need a replacement spring search for item# "SP-9702 spring". It's sold under a couple different brands under the same item number though.

This is my first remix and my first 3d modeling of any type I've done. It's challenging but very rewarding.