Garmin Edge 可定位/可移除/柔性安装支架

Garmin Edge Locatable/Moveable/Flexible Mount

2023-08-24 17:32:49

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Mounting for a Garmin Edge Cycle GPS. It was originally designed for a 130, but I think most "Edge" GPS units use the same mounting plate. In any case, you use your own mounting plate and the shorter of the rubber "O" rings supplied with the Garmin unit.

NOTE: This is designed for 32mm handlebars only. Thinner bars may need some creative padding in the clamp.

This can be used to locate the GPS in front, top or behind the stem as pictured. I found the original bracket when fixed directly to the handlebars caused the unit to interfere with the rest of the hardware on the bars when you tried to fix/remove the Edge.

You will need extra hardware - (all M4) - 1 of 25mm & 2 of 30mm countersunk bolts. 1 plain nut and 2 Nyloc nuts (5mm high if available, but full size 6mm are just fine).

Use one strip of 1mm adhesive rubber (or similar) to fit inside each clamp to prevent the clamp from twisting on the bars after fitment. You can use any 1mm sticky items, or just glue some rubber inside the clamp. Alternatively, three layers of electrical tape and/or masking tape will do just fine - anything to prevent the whole assembly twisting.

Using a long M4 bolt, pull the plain nut into the thumb-wheel until it locates at the bottom of the hole. It's designed to be a tight fit - ensure the hexagonal hole is a clean as possible from sprue/debris.

Assemble as shown in the diagram. The thumb-wheel fits from both sides as required.

Assemble the two pivot plates with the narrow channel mount-side (Pivot B) and the wider channel to the clamp-side (Pivot A).

When assembling, do not put too much torque on the lower clamp locknut you may split the clamp. Tighten both clamp nuts such that there is an equal gap either side of the handlebar. If gapped correctly, you don't need to loosen the clamp locknut at all when removing the unit from the bike.

Tighten the mount locknut just enough to allow the mount to rotate.

Observe the location/routing of the rubber "O" ring in the picture - it's from the front, not the back as you may expect.

"Always use the lanyard for extra safety".

If you find this Thing useful, please consider making a donation for my charity cycle ride Paris to London next month (September):

https://www.justgiving.com/petethevan68

(link expires 30 Sep 23)

Print Settings

Printer brand:
Geeetech
Printer:
Geeetech A10M
Rafts:
Doesn't Matter
Supports:
Yes
Infill:
More than 50%
Filament brand:
Other/SunLu
Filament color:
Black
Filament material:
ABS/PETG
Notes:
Print the clamps flat (lying down). This ensures that the layers run along the pieces to prevent cracking when tightened on the bike.