安亚库比克科布拉新锐Z轴步进式支架

Anycubic Kobra Neo Z-Axis Stepper Mount

2023-08-26 01:37:16

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a remix from a purchased part, not a thingiverse part.

When you buy a dual z axis kit, a lot of times they are Ender-specific and include t-nuts that you cant use because the anycubic version is different. Just print this out and use it to mount your stepper! Requires at least 2 M3 screws (ideally 4 for stability) and 4 t-nuts for the side-mount screws

Will most likely require you to remove the top bar, remove the pom wheels and slide the mount along the z-axis extrusions since they will be stiff and can't easily bend. They will NOT snap into place.

Finally, a tip about alignment: bring the X-Axis gantry / nozzle down as close to the bed as possible before you tighten up the M3 screws on the stepper motor. This will prevent the travel components from binding.

Print Settings

Printer brand:
Anycubic
Printer:
Kobra Go
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.3mm
Infill:
100%
Filament brand:
doesntmatter
Filament color:
doesntmatter
Filament material:
PLA or PETG
Notes:
print at 100% infill for strength!

the z axis motor shouldnt heat up excessively so PLA should be okay, but print in PETG if you have the option.