溶剂喷罩

Solvent Dipper

2023-09-07 17:32:40

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

A dipper used to submerging small electronics into solvents such as acetone.

The holes in the lid and base are 1mm in diameter, therefore you need to allow time for the inside to fill which might depends on your solvent.

This was made out of machine PTFE. If you are going to print this I would use 100% infill so no liquid can be stored in the infill.

V2: The surface tension of water stopped the water from entering the cell through the 0.5mm holes, upped hole size to 1mm.

V3: Water tension still too strong to overcome, added a vent for a pipette to manually alter the pressure inside the chamber to suck/blow water out. (In process of creating)

V4: Increased diameter of handle to make drilling of hole easier. Increased wall height and added spacer onto lid to reduce chamber height to 1mm while increasing the strength of the walls.