PSU测试器更换案例

PSU Tester replacement case

2023-09-07 17:34:35

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I had an old PSU tester, like the one in the photo.. it had that 'soft' rubbery coating and it went yuck... all sticky to touch.. so I designed a 3D printed replacement

The replacement is smaller than the original and uses the same screws, so you don't have to find anything else.. just take the four screws out from your old one, remove the PCB and place it into this new case, use the same 4 screws to close this up.
I included a photo of the front of the old tester, that I printed out and stuck onto my new tester, just so I know what lights do what.

two stl files, print without any drama..LEDs may need a bit of manipulating to get them into the holes, but they do all fit nice and snug.

Photos of the old sticky case.. the new case just printed and assembled and with the printed sticker on thje front..