Triangle Labs Voron 2.4跑出式支架

Triangle Labs Runout Mount for Voron 2.4

2023-09-07 17:34:54

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a mount for a Voron 2.4 for the Triangle Labs Runout sensor. There are three files, the mount itself, a corner clip with wire access and a modified corner mount for magnetic panels.

Wiring is run through the sensor mount, through the corner mount (if using magnetic panels) and under the the corner clip to the inside of the print chamber. Once inside the chamber, run the wires down the middle of the aluminum extrusion to the MCU. To hold the wiring in place down the center of the extrusion I use a foam sheet cut into 8mm strips (Foamies 11.81 Inch x17.7 Inch 3mm Black Foam Sheet, $7.45, at Amazon.com). Place the wire in the extrusion and force fit the foam over the top and the wires will stay in place and the foam is invisible against the black extrusion.

You will need two 3mm threaded inserts and the Triangle Labs sensor (TriangleLab Filament Runout Sensor Detector for 3D Printer 1.75mm Filament, $15.95, Amazon.com).

Klipper macros for filament change or M600 can be found on the net for your system.