CTRE 鸽子2.0支架

CTRE Pigeon 2.0 Mount

2023-09-08 02:45:22

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is a mount for the CTRE Pigeon 2.0 IMU. It mounts it to the two screw points on a RoboRIO. You will need two M3x12mm screws to mount the Pigeon to the print (though you may need to file down the heads of your screws so they can fit in the countersunk holes of the Pigeon) and two #4-40 1/4″ screws to hold the mount to the RoboRio. I'd recommend putting some VHB tape under the mount to reduce vibrations and hold the bottom snug to the RoboRIO.