Jet-Lift 3D模型材料过滤技术

Jet-Lift for matten filter

2023-09-08 20:41:38

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

This is basically an adapter that goes on the bottom of the uplift pipe. it has a ring of small holes around the perimeter that produces a curtain of bubbles along the wall of the pipe and no obstruction to the flow. The airline attaches to the jet-lift on the outside, and the design allows for very high flow, allowing you to run more tanks from the same air supply than you would otherwise.

you will need to superglue in a 1 or 2 inch section of rigid airline tubing to provide a place to attach the airline (i tried making the airline attachment nib part of the print, but it was just too fragile that way)

PLA with 3 walls and high infill works well. adjust the print orientation so that it prints\stands feet first (for some reason it exported upside down)

Print Settings

Printer:
custom
Rafts:
No
Supports:
No
Resolution:
.2mm
Infill:
50%
Filament brand:
any
Filament color:
any
Filament material:
PLA
Notes:
1) a small section of rigid airline tubing must be glued in to provide an attachment point for the airline
2) orient print right-side up (feet standing on bed) no supports should be needed. a raft may be handy if you have adhesion problems, I don't.