Dronetag BS Case

2023-09-10 05:15:42

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Comply with coming requirements with one of the lowest cost Remote ID solutions. Print this case and make 2 solder connections and you are ready to be compliant whenever the rule goes into effect (September 16, 2023 as of right now, but will likely be delayed). The full build, with Remote ID module, battery, wires, and case is just under 8 grams.

Once built, connect the battery, put the case on your drone, register with the FAA, and boom, you are fully compliant with the new regulations.

Since this will be in the sun, I recommend using PETG.

The case is designed with 0.8 mm walls.

Wiring:

The Dronetag BS can get power from either of the connectors. The 3-pin 1.0mm JST connector is specifically for power.

do not use the wiring colors shown in the photos as the polarity looks reversed where it goes into the board...use the information below to build your cables!

Pin 1 is +V (closest to the middle of the board)
Pin 2 is No Connect
Pin 3 is Ground (closest to the edge of the board)

See for more info.

FAA Notes:

Link to FAA UAS Declaration of Compliance for the Dronetag BS
Note: If you have a 249 gram drone, adding this transmitter will put you over the limit for recreational use without a registration. You can register your drone for 3 years for $5 here. Don't forget to add your Remote ID serial number to your registration to be fully legal.