Joycon杆和盖子3D模型

Joycon Stick and Cap

2023-09-10 05:42:22

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I've put this together after a friend of mine's daughter showed me her switch with two broken sticks. One was missing its cap and the other the entire stick.

This is a remix from two separate designs. The caps are from DragonRider115 on Cults3D and I've reuploaded it in its original form here as I felt it important to make it easy to download both from one site. But please do show your appreciation for the designer here:
https://cults3d.com/en/3d-model/gadget/nintendo-switch-thumb-grip

I then also found Akalime's stick here on Thingiverse, which fits nicely into the original switch joystick... hole. So wanting to make sure I had something that would match up, so this remix is to add DragonRider115's cap design be the top of Akalime's stick.

They seem to have all fit on quite nicely, but I stupidly didn't think to take photos of them once fitted, so you've got the before photos and the print photos but not the finished article I'm afraid

Print Settings

Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.1
Infill:
100%
Filament brand:
eSun
Filament color:
White
Filament material:
PLA+
Notes:
Print both upright, trust me, it'll come out hideous if you try printing it top side down.

Thumb caps

Use a support density of 20%

Sticks

The sticks are where things get complicated because those sticks are so small and intricate so we need to be careful and use plenty of support.

Again, sse a support density of 20%

Use a brim of 8mm and make sure it's set to Brim Replaces Support and turn off Brim Only on Outside.

On your speed settings, set those "number of slow layers" to 50 so we can really take it slow for those iddy bitty sticky bits at the bottom.

I hate supports too, but these ones come off super easy, just give them a good squeeze with some pliars (hell, I just bit it) and twist it off and you're done :)