可调节脚适配器用于货架单元

Adjustable Foot Adapter for Shelving Unit

2023-09-10 11:15:53

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

Have a couple of shelving units in my garage which has an uneven floor. Found some adjustable levelling feet at the local hardware store, so made these adapters.

Strongly suggest you put horizontal members just above the adapters secured with safety clips (see pics) in case a 3d printed adapter gives up the ghost. That way it should fail relatively safely and give you a bit of a warning.

Part references: (Australia)

Shelving unit (or equivalent) from Bunnings I/N 2760459.
Levelling feet are also from Bunnings I/N 0078251 ... can be longer but need an M10 thread (or just use an M10 hex screw and nut but put something under the head or you'll scratch the floor).

There are subtle variations in the size and pitch of the key-holes, that's why there are two versions of the safety clip. Print one of each first to see which one fits properly, before printing the rest (needs eight in total per shelf). The holes inside the bosses have different shapes so you can tell them apart.

Printed from Prusa PLA+ and they've been good for a couple of months now with about 50kg total on the shelves, but please build 'em solid (see Print Settings). Don't overload them, and use the safety clips. Also suggest you keep them out of direct sunlight to stop them warming up and softening.

Ensure the horizontal shelving beams are properly seated (mallet helps) and the keyholes are clear of excess powder coating (clean out with a rats tail file if needed). The L-shaped uprights vary in size, so the pocket is oversized, meaning the adapters can slip off the ends if you lift the shelving unit up.

Use a spirit level to get the shelves level; that's where the commercial feet are much better than the screws.

Check out more designs from Department_Nine!

Print Settings

Supports:
No
Resolution:
0.24-0.3
Infill:
50% minimum
Filament brand:
-NA-
Filament color:
Black
Filament material:
ABS, PETG, something STRONG (not plain PLA)
Notes:
ADAPTERS
- Build with at least four outlines and top/bottom layers
- Minimum 50% infill (square).
SAFETY LOCK
- 0.28mm layer height will result in 4 solid layers which should be flexible and springy enough
- If that's too stiff and the thin tab which holds the hollow locating pin in place bends or kinks, then drop it down a bit in the slicer and try to lose one or two of the layers.