瑞博连结支架，用于EGO 56V充电器

Ryobi Link Mount for EGO 56V Charger

2024-01-06 04:02:49

使用说明

所有模型资源均由用户上传分享，内容来源于网络公开资源
侵权投诉：通过抖音私信 @jobsfan 联系我们（需附版权证明），24小时内处理
模型将通过邮件发送（5分钟内自动发送），感谢理解带宽压力，超过1小时没收到，请联系我们

关于费用

我们是爱好者共建社区，为维持服务器成本，每个模型收取微量费用（仅覆盖基础开支）。我们承诺最低成本运营，感谢您的支持！

扫码手机访问

抖音私信 @jobsfan

Summary

I'm working on a garage organization project, and decided to make some mounts for the Ryobi Link system I purchased. I checked on Thingiverse for other Ryobi Link mounts, and while they kinda worked, I wasn't too thrilled with the loose fitment and when I dove into the models, they were kinda hack-ish (the asymmetry really triggered my inner OCD).

I instead decided to use some of the original Ryobi hardware, and armed with a pair of digital micrometers, I created an all new design. It has cutouts to reduce material waste, with ribs strategically placed to add rigidity as the EGO charger with a large battery is an absolute beast. It even has a lower "standoff" to slightly kick out the bottom so the charger sits square when mounted. Not sure if this works with all EGO 56V chargers, but I designed it for the basic charger that comes in the kit configuration with 3" screw spacing.
It works well with #8 x 3/4" sheet metal screws. It'll take a little muscle to screw them down, but again, you want this to be robust. Also, I built mine with a 1.6mm wall (e.g. 4 perimeters of 0.4 width), again, for increased rigidity and to make better use of the ribbing I designed.

These fit a bit tight, similar to the plastic Ryobi Link hooks, so they should be pretty secure. I used PLA because it's what I had, but of course there are better materials you can use. I personally would not use it anywhere the temperature can get warm enough to soften or deform the PLA. For those applications, you should try ABS, but I've never printed that material.

USE AT YOUR OWN RISK. These chargers are heavy, so it's up to you to determine if this mount is appropriate for your use. You don't want these falling on people, pets, cars, etc.

Print Settings

Printer brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
Standard 0.2mm
Infill:
40%
Filament brand:
ANY
Filament color:
ANY
Filament material:
PLA
Notes:
I recommend using a thicker wall than standard to let the ribs do the work. I went with a 1.6mm wall instead of the standard 0.8mm.